Menu
Download game cooking academy 1 full version gratis. This Star Water Systems Under Sink Water Filter reduces bad taste, odors, chlorine, organic chemicals, pesticides and herbicides. Lasts up to 3 years under normal conditions before needing to be replaced, unlike other smaller filters that need to be replaced each month.
Mario kart free download mac. Vision Systems. Video Measurement Systems. Video Inspection Systems. Optical Systems. Optical Comparators. Laser Measurement Systems. Tire Industry Products. Off-Line Profilometer 3D. Off-Line Profilometer. On-Line Profilometer. Ply and Belt Width Monitor. Green Tire Uniformity System. Tread Wear Imaging System. Get Star Water Systems S1104 User Manual. Get all Star Water Systems manuals! Garmin express download deutsch mac.
© Copyright 2011 Star Water Systems. All rights reserved.
STAR WATER SYSTEMS | 95 North Oak St. | Kendallville, IN 46755 | starwatersystems.com
Control Valve Programming and Use Instructions
DO NOT DEPRESS THE BUTTONS OUT OF SEQUENCE!
Display
Display
Indicator
x1000 Indicator
Icon
Icon
Button
Button
![]()
Button
Information
IL1030
Normal display
time of day and gallons
until regeneration
1.Plug unit into a 115 volt grounded outlet that is
independent from a wall switch or pull chain. When
2. Press and hold either the Up or Down buttons until
the programming icon replaces the service icon and
3. Adjust the displayed time with the Up and Down
4. When the desired time is set, press the Extra Cycle
also return to normal operation after 5 seconds if no
IL1031
AND FEEDWATER HARDNESS
1.Press the Up and Down buttons for five seconds while
in service, and the time of day is NOT set to 12:01 PM.
2. Use this display to verify the Day Override. This option
setting is identified by “DO” in the upper left hand
corner of the screen. The setting was factory preset to
display “OFF” for all water softener units and “3” for
S11TS32DR8 unit. If required, adjust valve by pressing
IL1032
3. Press the Extra Cycle button. Use this display to
adjust the Regeneration Time. This option setting is
identified by “RT” in the upper left hand corner of
the screen. The setting was factory set for 2:00 AM.
The regeneration time can be adjusted by pressing
the up or down buttons. Note the PM indicator on the
display. Regeneration time is when the unit will begin
a regeneration cycle. This should be set to a time of
4. Press the Extra Cycle button. Use this display to
adjust the Feed Water Hardness. This option setting is
identified by “H” in the upper left hand corner of the
screen. This value is your water hardness in grains per
023379
0211
Star Water Systems S1101 Parts
0810
Star Power Flush S1101 ProblemsSummary of content (2 pages)Comments are closed.
|
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |